These kilns were built upon request for Mountain Glass Arts because of the versatility of this particular size for bead makers. You can also anneal a good bit of borosilicate in these if you decide to in the future as well as convert it into a small fusing kiln. These kilns really are out of the park homeruns! Each kiln includes;

• Kiln Wash
• A 8" x 8" Kiln Shelf
• 4, 1" Square Kiln Post's
• 3, Aprox. 2" x 8" Kiln Feet To Elevate The Kiln Off Your Work Table
• A Fully Informative 43 Page Manual
• A Pre-Programmed Orton 3 Key Autofire Digital Controller With The Following Pre-Programmed;
• A Small Moretti Bead Program,  A Large Moretti Bead Program, A Batch Annealing Program, A Borosilicate Program and 4 Open For The User To Program
• 5 Programs For Silver or Gold Clay and 4 Open For The User To Program
• 6 Open User Programs
• 4 Large Piece Glass Fusing Programs and 4 Open For The User To Program
• 4 Small Piece Glass Fusing Programs and 4 Open For The User To Program

 
 
This is a top loading, stackable bead annealer. Features a full width, 2 inch high bead door at the bottom for resting mandrels. 8" x 8" square, 9" tall, inside; 120 volt, 15 amp, 1800F max. Includes Jen Ken Orton Autofire 3 Key digital contoller. Remove the lower, blank, firebrick ring to use as a 8" x 8" x 4.5" tall fusing kiln (2400F max. temp.). Ships via UPS, 55 pounds shipping weight.