Jen Ken Digital 8" Wide x 8" Deep x 9" Tall Bead Kiln W/Door

These kilns were built upon request for Mountain Glass Arts because of the versatility of this particular size . You can also anneal a good bit of borosilicate in these if you decide to in the future as well as convert it into a small fusing kiln. These kilns really are out of the park homeruns! Each kiln includes;

• Kiln Wash
• A 8" x 8" Kiln Shelf
• 4, 1" Square Kiln Post's
• 3, Aprox. 2" x 8" Kiln Feet To Elevate The Kiln Off Your Work Table
• A Fully Informative 43 Page Manual
• A Pre-Programmed Orton 3 Key Autofire Digital Controller With The Following Pre-Programmed;
• A Small Moretti Bead Program, A Large Moretti Bead Program, A Batch Annealing Program, A Borosilicate Program and 4 Open For The User To Program
• 5 Programs For Silver or Gold Clay and 4 Open For The User To Program
• 6 Open User Programs
• 4 Large Piece Glass Fusing Programs and 4 Open For The User To Program
• 4 Small Piece Glass Fusing Programs and 4 Open For The User To Program

This is a top loading, stackable bead annealer. Features a full width, 2 inch high bead door at the bottom for resting mandrels. 8" x 8" square, 9" tall, inside; 120 volt, 13 amp, 1800F max. Includes Jen Ken Orton Autofire 3 Key digital contoller. Remove the lower, blank, firebrick ring to use as a 8" x 8" x 4.5" tall fusing kiln.



Ship Size: 24Wx24Dx19H Inches

Ship Weight: 60 pounds

This Kiln Ships Via UPS and is subject to a UPS oversize box charge.



All Jen-Ken kilns are covered under a 2 year warranty from Jen-Ken.